Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-15-2000, 06:49 PM
|
#1 |
|
Registered Member
Join Date: Jul 1999
Location: rocky point, NY ,USA
Posts: 65
|
I have the MAC kit and it looks really good but I had to modify it to fit with my strut tower brace( cut about 1inch off the end where ir connects to the TB).I also took out the elbow that goes down in the fender because I think it was messin with my Mass Air(stock)makin my rpms at idle low and fluctuate.I'll try it again when I get a new Mass air, but it still looks good in there.Hope this helps a little.
------------------ 1999 GT AOD,FMS 70MM TB,Steeda pullies,Dynomax Super Turbos,MAC cold air kit,Steeda strut tower brace,ATS-III seq. turn signals |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Check Coolant light on when cold | Tecknowolf | Windsor Power | 2 | 09-14-2003 06:35 PM |
| cold air intake | TRipSOber | Modular Madness | 13 | 05-01-2003 03:49 PM |
| Cold cold air induction!!!!!! | 01 BLACK GT | Modular Madness | 3 | 07-18-2001 02:10 PM |
| I cannot believe I forgot to ask about Cold Air intakes. | SlowStang2 | Windsor Power | 1 | 07-16-2001 06:26 PM |
| too much cold air? | 93SVTstang | Windsor Power | 17 | 01-26-2001 07:06 PM |