prices for install

91PA5liter · 01-11-2003, 06:30 PM

im most likely going to be getting some stock heads from a friend for free and porting them my selfand putting either 1.6 or 1.7 rockers on them. I figure since to put the heads on i need to take the intake off i might as well get a better on and put it on then too. So obviously im thinking of adding a cam at the same time. What would be a good intake and cam to match up with these heads and what should i expect to pay for install of this? thanks for the input
Ryan

bottlebaby91 · 01-11-2003, 06:47 PM

Stock heads with a little porting..........i would say an eldlbrock performer and an e-303 cam

91PA5liter · 01-12-2003, 08:46 PM

what about the Trick Flow intake would that work well? The only reason i ask this is because i found that intake for cheaper and budget is a concern for this my pockets arnt too deep. I will also be running a 75 shot of nitrous with this set up if that makes a difference to what i should be putting into the car. Also with a new intake and cam would i need bigger injectors with this?
ryan

01-11-2003, 06:30 PM	#1
91PA5liter Registered Member Join Date: Jan 2002 Location: PA Posts: 79	prices for install im most likely going to be getting some stock heads from a friend for free and porting them my selfand putting either 1.6 or 1.7 rockers on them. I figure since to put the heads on i need to take the intake off i might as well get a better on and put it on then too. So obviously im thinking of adding a cam at the same time. What would be a good intake and cam to match up with these heads and what should i expect to pay for install of this? thanks for the input Ryan

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need good prices on engine rebuild kits	82 GT	Windsor Power	1	11-21-2002 02:03 AM
gas prices	mustang145	Built Ford Tough	5	04-02-2001 05:38 PM
gas prices	mustang145	Blue Oval Lounge	10	03-09-2001 04:20 PM
gas prices	mustang145	Windsor Power	4	03-09-2001 02:02 AM
gas prices	mustang145	Small Ponies	0	03-08-2001 11:32 PM

01-11-2003, 06:47 PM	#2
bottlebaby91 Registered Member Join Date: Nov 2002 Posts: 141	Stock heads with a little porting..........i would say an eldlbrock performer and an e-303 cam

01-12-2003, 08:46 PM	#3
91PA5liter Registered Member Join Date: Jan 2002 Location: PA Posts: 79	what about the Trick Flow intake would that work well? The only reason i ask this is because i found that intake for cheaper and budget is a concern for this my pockets arnt too deep. I will also be running a 75 shot of nitrous with this set up if that makes a difference to what i should be putting into the car. Also with a new intake and cam would i need bigger injectors with this? ryan