

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Jan 1999
Location: Oxford, KS
Posts: 935
|
![]() And the winner is:
Mustanguy Congrats and thanks to everyone for guessing. In case you all are wondering, we dynoed January 30th. Horsepower 658 @ 6869rpm Torque 556 @ 5353rpm Torque stayed well over 500 from 5100 through 6600 rpm. All in all I am pretty happy with the results. We were unable to use my headers for the dyno session as they would not work. I imagine we would have likely seen an additional 10-15hp as the ones we used would not flow near the air. It's amazing how important tuning is. Timing was set at 32 degrees. Advancing to 34 degrees dropped 50hp. Reducing 1 jet size gained 20hp. Little adjustments here and there can make a huge difference. Again, thanks for the guesses! ------------------ SVO siamesed 351 stroked to 417ci,Yates heads, solid roller,Trans King glide and a little blue bottle of giggle gas. My Car |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
TFI module part # | GhettoPop | Windsor Power | 2 | 02-12-2004 01:34 PM |
How can I tell if a part will pass emmisions? | Kamaro Killer | Windsor Power | 2 | 09-08-2002 07:05 PM |
Looking for Bosch part #'s! | chris91LX | Windsor Power | 0 | 12-28-2001 06:58 PM |
Need help finding Ford part numbers | Capri306 | Windsor Power | 0 | 03-30-2001 10:13 AM |
Hard to locate part for 83 stang help!!! | 83stanger | Small Ponies | 0 | 03-02-1999 08:52 AM |