Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-15-2002, 11:45 AM
|
#1 |
|
Registered Member
Join Date: May 1999
Location: sloatsburg
Posts: 261
|
tunning ?
Hey ive been working on tunning my car and just had a couple questions about the carb what should i set the sight levels at on the carb they are the clear type and everyone says to keep them at half but what would be some advantages and disadvantes to going higher or lower also there are four scres one on each side of the bowl the video i got said to turn them a turn and a half out what would be the advantages to turning them more or less. I have my fuel pressure set at about 6 to 7 and my timing with the vacum line off the dist is about 14 any suggestions would help me alot im taking it to englishtown this fri for its first timmed runs.
__________________
306 edelbrock 6037 heads full mac exuast 1.7 rr 373 rear hd clutch tremec mighty demon 650 carb msd ignition rpm air gap intake custom cam still trying to get it to run right |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| supercharging tunning | 1_fine_89 | Windsor Power | 2 | 11-28-2003 01:26 AM |
| New cam, tunning again | 88workcar | Windsor Power | 9 | 11-17-2003 06:15 PM |
| tunning my 5.o? | whitepony | Windsor Power | 1 | 09-03-2003 02:46 PM |
| Nitrous and tunning | Mustang_289 | Power Adders | 6 | 05-08-2003 11:54 AM |
| Help tunning Holley 600 | 66 Racer | Classic Mustangs | 3 | 08-08-2001 11:37 AM |