Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-20-2003, 08:01 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Hampton, Virginia
Posts: 227
|
Cam Bearing
Is there a special tool needed to remove the cam bearings?
I have the engine block bare and it has some surface rust at the top two inches of the bore, very fine. If I hone it smooth and measure it, how far can you go before having to bore it up a size? If I confused anybody let me know?
__________________
1980 RX7 with 289 Ford V-8 bored .030 over, Very radical cam, Torker 2 high rise intake, Holley 650 Carb, MSD Nascar 6ALN ignition, MSD coil and distributor, Headers with dual open side exhaust. Over 300 horse. 1966 Mustang still in progress |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Throwout Bearing Blues | Rstng93 | Blue Oval Lounge | 2 | 06-19-2004 07:41 PM |
| Does the T-5 pilot bearing need to come out for an AOD to go in? | crazypete | Windsor Power | 14 | 11-06-2003 11:04 PM |
| Pilot Bearing | Cody2552 | Windsor Power | 2 | 04-09-2003 09:30 AM |
| Pilot bearing replacement | Rebel79 | Windsor Power | 8 | 05-31-2002 02:12 PM |
| throwout bearing noise!! | Coupe5oh | Windsor Power | 1 | 04-30-2002 05:38 PM |