Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-07-2002, 11:52 AM
|
#2 |
|
Founder
Join Date: Jun 1995
Location: Michigan
Posts: 19,326
|
Darius, does the valve covers have punched spots underneath at each end where you can cut your breather opening? I had to do this with my tall motorsport covers also. By using a circular saw/drill at the punched spots it wasn't that hard. Then I just cleaned it up with a file I think...
__________________
StangFlyer 1991 Mustang GT - Supercharged 377 Stroker 2000 Ford Lightning - Project Lightning Hauler Media Center Gallery - View my member photos |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Victor Jr. manifold is in - have questions about breather cap on valve covers | Stang_ROTY | Windsor Power | 2 | 08-19-2004 09:39 PM |
| Need tall valve covers + breather tube | Hozer 88GTConv | Windsor Power | 0 | 01-31-2004 10:58 AM |
| Is a valve cover breather bad for the 4.6???? | 96_4.6 | Modular Madness | 6 | 08-21-2003 06:38 PM |
| smoke out the breather valve!! | 82 GT | Windsor Power | 3 | 09-21-2002 02:01 PM |
| Why do I see some high performance engines w/ breather caps on the oil spout?????? | Stang_ROTY | Windsor Power | 24 | 08-18-2001 12:28 AM |