Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-20-2001, 11:49 AM
|
#1 |
|
Registered Member
Join Date: Feb 1999
Location: Camarillo/Thousand Oaks Ca
Posts: 223
|
tuning?!?!?!
OK the motor is in and has about 200miles on it... im am starting the fine tuning process well i know i am ruinning low fuel pressure (about 2psi above stock) and the timing is at about 12* but the air:fuel gauge looks fine under no load but when i am driving it bounces back and forth between lean and rich all the time... what is going on.... what is the gauge supposed to be at during idil anf WOT????
thanks se sig (NO 24lbsERS YET!!!) ------------------ ALL NEW PPG Torch Red 95GT, 304ci block, Forged pistons, Ported Explorer Intake, E-303 cam, fully ported and polished and milled E-7 heads, 75mm MAS, BBK Adj. fuel Reg & gauge, BBK Shorty Headers, BBK H-pipe, March Pulleys, 2 Chamber Flowmasters, Kenny Brown 6 point Roll cage, Kenny Brown Panhard Bar, Powerslot Rotors, PBR twin piston calipers, Eibach Sportline Springs, 180* Thermostat, 1/2 Plenum Spacer, MSD 6AL, MSD Master Blaster, MSD 8.8 Wires, 24# Racing Injectors, AFS 10.5" Cobra R's, Nit |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Computer tuning guys, Help | KiltedBanshees93GT | Windsor Power | 0 | 02-29-2004 07:28 PM |
| 5.0 tuning | jeffnichols | Windsor Power | 1 | 11-27-2003 01:35 AM |
| Dyno Tuning for Racers... | RadialPrincess | Racer's Club House | 1 | 01-26-2002 07:34 PM |
| Who does good tuning? | 8850 | Windsor Power | 5 | 09-29-2001 02:52 PM |
| Tuning issues after new combo installation | cojonepony | Windsor Power | 2 | 08-16-2001 09:09 PM |