Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-02-2002, 11:12 PM
|
#1 |
|
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
393 or 408 more reliable?
ok, I got a 351w block today, its a 1974 Casting. My question is do I go with a 393 or 408 stroker. All parts equal quality, which is better and more reliable? Any downfalls to either? This is not a daily driver, but more of a Strip/street car with carb. Also it will be roller motor. Detailed input appreciated, as it's time to make some decisions and have never built a stroker before.
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How reliable are the new 4.6 motors? | LS1JAY | Blue Oval Lounge | 11 | 02-11-2003 02:50 PM |
| How reliable is a 5.0 | vtechatch | Windsor Power | 30 | 01-03-2003 09:51 AM |
| pushrod vs. O/H cammer RPM ranges | Mach 1 | Windsor Power | 2 | 07-27-2002 01:46 PM |
| reliable heads | evilmustang | Windsor Power | 5 | 06-14-2001 09:47 AM |
| Reliable Zex nitrous results are in!! | Hammer | Modular Madness | 4 | 06-06-2000 02:11 PM |