Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-05-2003, 07:11 AM
|
#1 |
|
Registered Member
Join Date: Jan 2003
Location: Indianapolis
Posts: 41
|
Cam Shaft Removal???
I'm having a problem getting the cam shaft out of my 289. It will only move about a 1/4" towards the front and it stops. This is the only thing left on my block and I don't know what the problem is. I took off the two bolts that hold the thrust plate and the thrust plate. From what I read, it should just slide out. It will spin but it won't come out. Any help would be appecriated.
__________________
66 Coupe Project, 289-C4 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Input Shaft | Phantom5oh | Windsor Power | 10 | 05-31-2002 01:51 PM |
| ARP oil pump drive shaft problems | yellowspeedster | Windsor Power | 2 | 05-20-2002 05:18 PM |
| Distributor alignment with Oil Pump Shaft | Dopie | Classic Mustangs | 4 | 12-03-2001 06:59 AM |
| Where is the output shaft? | 91LXConv | Windsor Power | 2 | 03-01-2001 05:28 PM |