Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-30-2001, 05:42 PM
|
#1 |
|
Registered Member
Join Date: Jul 2001
Location: Taxachusetts
Posts: 374
|
Exhaust musings...
My car needs some exhaust work. The right-side muffler decided to detach itself, so now I have half an open exhaust.
I'm getting the entire thing replaced with custom mandrel-bent stainless steel. I've decided on Hemi Super Turbos. My two questions are as follows: If the car is otherwise bone-stock, and I drive almost exclusively on the highway, will I be better off with an X-pipe? Also, remembering that it's bone-stock, should I throw on a set of equal-length headers? My reasoning is that I'm probably never going to work on the exhaust again, and if it's going to be in an exhaust shop, I might as well put _something_ on it. Do equal-lengths cut down on your low-end torque? |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra-R Side Exhaust -- SWEEET! | SkammyManX | Modular Madness | 3 | 04-05-2003 11:58 AM |
| Speed Secret # 4 | jim_howard_pdx | Windsor Power | 13 | 11-10-2002 03:42 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Header gaskets | Stang951 | Windsor Power | 18 | 11-01-2002 05:57 PM |
| Important Exhaust Question - Please Read | sublimelax | Small Ponies | 14 | 03-06-2001 10:14 PM |