Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-25-2002, 09:08 PM
|
#14 |
|
Registered Member
Join Date: May 2001
Location: Oklahoma City OK USA
Posts: 236
|
The oil control issue with most 347 kits, as i am told, comes from the fact that the wrist pin intersects the rings. Coast High Performance has a 347 kit that they have supposedly fixed that problem with. I would very much like to hear from som of the owners of those kits to see what they think. I am going to buy the cost high kit and use some gapless rings and pe o get 75,000+ miles
__________________
90 GT 25th Anni. Did the AOD to T-5 swap, SPEC clutch, Steeda Tri-Ax shifter, BBK 2½ inch off-road H pipe, Flows, BBK 70mm TB/EGR, Ford Racing aluminim driveshaft, 3.55's, welded subframes, Ram Air, 3 core radiator, NOS dry kit 75 shot, and a K&N filter. 12.9 @ 108 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building a stroker motor | Mustang_289 | Windsor Power | 4 | 02-17-2005 12:46 PM |
| 'super' stroker vs 'budget' stroker | mike5p01 | Windsor Power | 4 | 10-11-2003 10:11 PM |
| 351w or 347 stroker? which is better? | BLACK85GT | Windsor Power | 55 | 12-21-2002 06:52 PM |
| Decided to build a stroker, but where do I start? | WhiteLX | Windsor Power | 5 | 12-16-2002 10:35 AM |
| stroker engine question | 82 GT | Windsor Power | 1 | 06-08-2001 03:22 PM |