Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-06-2002, 05:29 PM
|
#1 |
|
Registered Member
Join Date: Nov 2001
Location: Daly City CA USA baby
Posts: 42
|
Aftermarket cam?
was up guys
i really want to know if ne body has used or has any info on the use of an aftermarket cam with stock heads, and intake. i am currently looking into the E303. if it isnt a good idea with the heads being stock and the intake being stock will it work well with just the after market upper lower intake? basically if i got the gt-40 intake and a E303 cam would that work well with my set up? i dont want to change the heads yet, because i am in need of a new engine and i dont want to ruin new heads. i currently have an 89 gt 5 speed. thanks----- danny
__________________
off road h-pipe , under drive pulley's , stage one center force clutch, removed air silencer, flows, K&N, 130 Amp pain in my alternator, optima yellow top 3.73 gears aluminum drive shaft and pro5.0 shifter... |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AFtermarket or factory fender | 7up | Windsor Power | 13 | 08-19-2002 11:30 PM |
| 99+ GT aftermarket exhaust | MattwantsSpeed | Small Ponies | 1 | 06-29-2002 10:15 AM |
| anyone weighed their stock and aftermarket hoods? | fiveohpatrol | Windsor Power | 11 | 11-24-2001 10:21 AM |
| How do I identify a(n) (aftermarket) cam? | Gautam | Windsor Power | 13 | 04-14-2001 09:32 PM |
| Aftermarket 4.6 Heads & Manifolds & Blocks...WHERE ARE THEY!! got any ideas? | Shawn | Modular Madness | 3 | 09-26-2000 02:07 PM |