Problem with timing for a 302 HO.

[cmd]

Hi, Just want to say Thanks, I did what you said and I am on the road today. And it feels go to have the stang running again.

Originally posted by QuantumMotorsports:
To get the timing close, turn the crank by hand with a wrench on the crank end bolt until the timing mark is right on the arrow for correct timing. Take the distributor cap off and look to see where the rotor is pointing. With the timing mark in the correct location the rotor should be pointing either straight at the #1 cylinders point or 180 degrees from the #1 cylinders point(on a four cycle engine the piston hits TDC (top dead center) twice in it's cycle, once when it is pushing exhaust out and about to take air in, and once when firing. Make sure it is at one of these two places and try and crank it over. If it won't start, pull the distributor out and rotate the rotor 180 degrees and slide the distributor back in. Try again. Be very careful while doing this and if you're not very experienced you might want to find someone who can help. Good luck.