Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-17-2002, 01:17 PM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
Just installed hawk pads........
I Just installed a set of hawk street plus pads on the front. Its like night and day. Anyone wanting a cheap upgrade, here it is.
My real question is, I was having squeaking noises coming from the front wheels. I thought it was the indicators on the pads but it still squeaks the same with the new pads. I did put anti-squeak goop on the backing plates when i installed them and did not remove the rotors. It was not warped or grooved at all to my surprise (I confirmed with a run-out guage), I then broke the glaze up with some 150 grit sand paper and cleaned it with brake cleaner. It still squeaks! Any sugestions? Perhaps wheel bearings? It really stinks to drive into a "hot spot" and have everyone stare at you when it squeaks.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| installed pa performance alt | GhettoPop | Windsor Power | 1 | 04-11-2004 09:42 PM |
| CAI Installed Whew!?! | mustardjohn | Small Ponies | 0 | 11-08-2003 05:32 PM |
| Eibach Springs Installed | COUSIN ROB | Modular Madness | 0 | 05-13-2003 09:17 AM |
| Replacing Brake Pads on 96 F150 | jimberg | Built Ford Tough | 2 | 08-26-2002 04:01 PM |
| Getting Novi 1000 installed Wed. | Chris_H | Windsor Power | 3 | 12-31-2001 07:22 PM |