Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-16-2001, 03:38 PM
|
#18 |
|
Registered Member
Join Date: Nov 1998
Location: Salina, KS
Posts: 83
|
93CobraR - Sorry for the long delay, haven't checked this site for a while. I used the stock pushrods. I get quite a bit of valvetrain noise though, but I think it is from the noisy 1.7 rockers and using stock pushrods with my P heads that have been milled .030. I probably shoulda got a new length, but it wouldn't have been hardly any difference. I should just re-torque the rockers and it would probably fix it. As for the cam pin, I am not sure which one we used.
------------------ 91 GT - Cobra Intake, FMS 65mm TB, C&L 73mm MAF, GT-40P heads, Crane 2031 cam, Crane 1.7rr, Built AOD, Art Carr 2400 non-lockup converter, Transgo shift kit, BBK cold air, FMS 'P' headers, Pacesetter off-road H, BBK aluminum pulleys, Flows w/dumps, FMS 4.10's, Steeda STB, StangNet LCA's, for now... Original GT-40P Tech Page |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| timing gears or chain? | 66StangGuy | Classic Mustangs | 8 | 11-09-2002 03:47 PM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| Ford Racing Timing Chain QUESTION. PLease HELP | 89FHPLX | Windsor Power | 3 | 06-27-2002 12:28 AM |
| Mech. fuel pump cam doesn't fit new timing chain? | 7000rpmisheaven | Windsor Power | 7 | 03-12-2002 08:55 AM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |