Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-25-2004, 12:27 AM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Ft. Worth, TX
Posts: 456
|
TPS reading 1.0V all the time... WTF?
Recently pulled codes on my car just to kill time and got a TPS too high code. I have checked it several times before when doing intake installs etc... and never had a problem getting it to read < 1.0 at KOEO.
After getting the code I checked it with a DMM and it read 1.0 at KOEO. No matter what position I put it in it reads 1.0. Even doing the full throttle sweep it reads 1.0. I put a spare TPS on and it did the same thing. I am using the green wire and grounding the other lead just like always. What is causing this? Anybody have this happen before?
__________________
You're gonna need your seatbelt |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Long Time No Post | OnMy3rdStang | Blue Oval Lounge | 4 | 12-05-2004 10:34 PM |
| My report from racing at the NMRA event in Bowling Green (was ATTN: Lt. Dan) | andy669 | Racer's Club House | 12 | 10-08-2003 02:41 PM |
| My new suspension worked! .4 off 1/8 mile time! | 84LX89GT | Stang Stories | 13 | 04-17-2003 06:38 AM |
| Its time for a new sig.... | Hammer | Blue Oval Lounge | 3 | 10-23-2001 08:52 AM |