Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-26-2004, 10:28 PM
|
#1 |
|
Registered Member
Join Date: May 2004
Location: Tennessee
Posts: 21
|
Engine Over REVs on its own!!!
My problem is this: Sometimes when I shift between 5300-6000RPM the moment I push the clutch in, the engine flares beyond 6500 (off the gauge) and hangs there, if I shift before 5000-5200 it will never do this. the only thing that stops the engine flare is turning off the engine, when I turn it back on again its fine.
What is strange it did this with a completely stock engine as well, before I put my combo listed below in there. What would cause the throttle to conditionally stick only between those RPMs?
__________________
306,Hyper Pistons,Edelbrock Performer RPM "Typhoon" Intake (Ported), 1969 351W Heads (ported) 60cc combustion chambers machined to 50cc, 10:1 Compression Ratio, F-303 Cam, Harland Sharp 1.6 Ratio Roller Rockers, A9L ECU, 70MM Cobra MAF, 24lb/hr Injectors, MAC Equal Length Headers, MAC Offroad H-Pipe with Flowmaster Mufflers, 3.55 Posi Rearend...dreaming of 12s, need to run it |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rare Mustangs....Got One? | 1969Mach1 | Blue Oval Lounge | 22 | 09-25-2010 04:59 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Small Ponies | 0 | 05-12-1999 02:27 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |