Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-13-2005, 07:06 PM
|
#2 |
|
Registered Member
Join Date: Nov 1998
Location: Houston, Tx.
Posts: 3,887
|
Re: Honing Mistake?
If it was professionally built, I'd be questioning the builder as to the spun bearing at 2000 miles? If the clearances were right to begin with, I can't see why the bearing spun? As I said earlier, I would be going back to that builder with the engine and some very pointed questions.
Rev
__________________
'66 Coupe, 306, 350-375 HP, C-4, 13.07 e.t., 104.8 mph, 1/4 mi. O.B.C. #2 '66 coupe |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tremec TKO II w/ 0.82 OD and 3.73 rear end... Mistake? | Treachery | Windsor Power | 4 | 11-15-2004 08:23 PM |
| Oil anyone?? Made a little mistake... | msunickb | Windsor Power | 6 | 04-20-2003 11:46 PM |
| Stupid Mistake, how do I fix it? | AdamM | Windsor Power | 1 | 07-14-2002 01:58 PM |
| Anyone else make the mistake of auto-xing an AOD? | LOCASH | Corner Carvers Delight | 3 | 04-05-2002 04:22 PM |
| mass air mistake | Paul Grande | Modular Madness | 4 | 01-30-2002 02:23 AM |