Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-05-2005, 09:44 PM
|
#3 |
|
N-V-ME
Join Date: May 2005
Location: SOUTHFIELD,MICHIGAN
Posts: 155
|
Re: Welding On Axel Tubes Question........
110v 100 AMP STICK ARC WELDER.......IT WAS CHEAP COULDNT PAST IT UP,,,,,,,I WAS WELDING ON STOCK SLAPPER BARS , DID IT TO DAY DIDNT TEST THEM YET ....I HAVE THEM GAPPED ABOUT 1/4 IN. FROM THE LOWER CONTROL ARMS WHILE TEST TOMORROW...........
__________________
88' LX MUSTANG: LINCOLN ROTORS , AIR SUSPENSION FRONT AND REAR, SUBFRAMES, ROLL CAGE, 92' BLOCK, MSD 6AL, ACCEL 8.8 WIRES, ACCEL COIL, EDELBROCK F4B INTAKE (PORTED),2 IN. 4 HOLE SPACERS, HOLLEY 600 CARB.,HOLLEY BLUE FUEL PUMP AN REGULATOR, E 303 (.498 IN. 220 DUR.) CAM, (.535 IN. OF LIFT W/ 1.72 SCORPIN ROLLER ROCKERS), PORTED E7'S, FLOWTECH 1 5/8 LONG TUBE HEADERS, 2 1/2 IN. H PIPE, 2 CHAMBER FLOWMASTERS WITH 3 IN.DUMPS, T-5, 3.73 GEARS, 5 LUG AEROSTAR AXELS, 245-45-17 96' COBRA WHEELS |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| BBK long tubes on P heads | procharge94 | Windsor Power | 0 | 05-04-2005 03:05 AM |
| simple question | Lonzo | Classic Mustangs | 3 | 09-10-2002 09:37 AM |
| welding H-pipe question | 84LX89GT | Windsor Power | 5 | 07-28-2002 11:46 PM |
| TFS High Ports and Long Tubes | HORSEMEN RACING | Windsor Power | 3 | 07-16-2002 12:57 PM |
| another stupid axel question? | glxstang | Windsor Power | 1 | 04-01-2002 08:53 AM |