Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-22-2001, 10:40 PM
|
#1 |
|
Guest
Posts: n/a
|
changing cam
can i physically take out my cam while it's in the vehicle, is there enough clearance if i remove my radiator...what would you guys recommend i do. Should i remove the front nose also? I have a 5 spd so there is no trans cooler in front of the radiator.
Also: kind of related. I'm going to put on a dual plane intake (haven't decided what yet) and have a holley 600cfm carb. What cam would you guys recommend for a decent condition 150k mile block with 600cfm Holley, stock E7TE heads, 1 5/8" shortys and 2 1/2" exhaust. I have some concerns about revving the piss out of it, so i'd like a strong mid range cam. Any ideas? Thanks |
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| changing a rear end | ragtop5point0 | Windsor Power | 7 | 02-06-2003 01:37 PM |
| changing the stock grille and emblem | pjc01 | Appearance & Detailing | 1 | 04-01-2002 12:02 AM |
| changing automatic transmission | msisido | Windsor Power | 2 | 03-11-2002 05:31 AM |
| Changing ring & pinion gear is illegal | Ripper | Modular Madness | 1 | 04-06-2000 12:45 PM |