Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-04-2001, 11:47 PM
|
#5 |
|
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
I would stay around .530 to be safe, if the valves float it could get ugly with anything more. If you need a little extra clearance the ROL graphite gaskets are .051" thick, most gaskets run .041 thick when compressed
------------------ My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| South Side Machines Lift Bars..... | cucho | Windsor Power | 7 | 01-29-2004 10:51 PM |
| stock gt40p lift and high lift cams | homeroV8 | Windsor Power | 0 | 11-28-2002 10:34 AM |
| cam lift question | redsn95vert | Windsor Power | 1 | 04-28-2001 09:58 PM |
| SSM lift or Lakewood lift bars | ponypower | Windsor Power | 10 | 02-11-2001 07:26 AM |