Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-20-2001, 03:58 PM
|
#1 |
|
Registered Member
Join Date: Oct 2001
Location: avon lake,ohio usa
Posts: 7
|
FMS cam selection
This coming winter I am looking to install an aftermaket cam into my cobra. The GT40 iron heads are still on the car. I was looking into installing an F-cam. Does anyone run this cam, and will this work well with my heads or is it to aggresive. Will I need new valve springs and rockers or will the current 1.72s work. I'm looking for more upper RPM hp, but cant rev too high stock bottom end with rev limiter still at 6250.
__________________
95 Cobra 302 Mods- BBK longtubes,off road h-pipe,flowmasters,underdrives,cold air,75mm maf,70mm t.b. fuel reg,steeda tri-ax, and 4.10s with nittos. Best ET/13.08@104.1 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Optima battery selection | PWR_RYD93 | Windsor Power | 12 | 01-12-2004 01:09 PM |
| cam selection | avbcon12 | Windsor Power | 42 | 10-10-2002 08:22 AM |
| Intake selection with a 383/408 stroker | Capri306 | Windsor Power | 12 | 05-03-2002 10:12 PM |
| Gear Ratio Selection | Green96GT | Modular Madness | 4 | 07-19-2001 11:40 AM |
| Gear selection | Grulla | Corner Carvers Delight | 1 | 03-13-2000 09:04 AM |