Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-28-2001, 01:03 PM
|
#1 |
|
The Photoshop Guru
Join Date: Feb 2001
Location: Mecca, Indiana
Posts: 1,419
|
Machining on a stock throttle body - can it be done??
I am in dire need of a throttle body and was wondering if a stock TB can be machined out to about 65mm or even bigger. I am a machinist and have all the coolest machinery available to me to do it so that's not the problem.
I know I'd have to make a new throttle plate. Anyone know how to go about doing this or know where I can find an article with specs and such? ------------------ ICQ# 42269241 Indiana Stangers Association Buy your parts here |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bbk/edelbrock Throttle Body Sticking | sn95gt19 | Windsor Power | 4 | 06-25-2002 02:01 PM |
| Does your BBK Throttle Body "whistle"? | Stang_ROTY | Windsor Power | 22 | 06-12-2002 06:33 AM |
| Throttle Body and MAF | Rosco | Windsor Power | 4 | 03-20-2002 05:21 PM |
| fuel pump and throttle body | nextime | Windsor Power | 10 | 03-15-2002 09:40 PM |
| throttle body ??? | Fostang | Windsor Power | 0 | 02-05-2002 01:57 PM |