Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-23-2000, 08:53 AM
|
#7 |
|
Guest
Posts: n/a
|
Mostly it is preference, but I would run cheap ones, like Mr. Gasket header gaskets. Just in case if a header bolt comes out and burns up the gasket you can just get another cheap set. I have used these on all the motors I have put together and have had success. Good Luck.
------------------ 88GT stock shortblock, ported GT-40 iron heads, ported Edlebrock Performer intake, 24# inj, Pro-M 75mm Bullet MAM, 3.73, hurst short throw, F-303, electric fan, alum rad, FMS HD clutch, R134a ac conversion, 70mm TB , and some other stuff I probably forgot, best run so far on ET streets is 13.02@106 with a 1.87 60ft. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| head gaskets...GOOD ones | 88workcar | Windsor Power | 9 | 03-26-2003 06:06 AM |
| Intake and head advice | taurus3298 | Windsor Power | 3 | 05-09-2001 06:55 PM |
| Head ID and Extrude-honed Upper intake | RSE1805 | Windsor Power | 1 | 03-23-2001 05:03 PM |
| Gaskets - Which ones and where do I get them from? Please help quick. | 2FastLX | Windsor Power | 1 | 03-14-2001 12:08 PM |
| Where to get TFS intake gaskets? | gt93mustang | Windsor Power | 1 | 02-04-2001 05:09 PM |