Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-31-2002, 01:28 PM
|
#2 |
|
or '331 LX Eric'
Join Date: Jan 1999
Location: Columbus, Ohio
Posts: 2,142
|
I have Autometer mechanical gauges on my Stang. I'm not sure which is more accurate - probably debatable. But, as long as you stick with a reputable name (i.e. Autometer, et al.) you should be fine - definately much better than the stock gauges.
The installation is very easy too. If you have specific questions, post them and we will try to answer them. Good luck, E
__________________
1991 5.0 LX Coupe - 40,750 miles 331 cu. in. / Tremec 3550 / BFG Drag Radials 12.22 @ 114.31 mph - w/1.89 60' |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Want White Face Gauges Any Opinions ? | 98GTNewbie | Appearance & Detailing | 0 | 08-28-2003 02:10 PM |
| Reverse lit gauges - oil, EGT, fuel | speedemn | Audio, Security, & Electronics | 2 | 05-24-2003 02:06 PM |
| Gauges?? | SleeperGT | Modular Madness | 2 | 03-03-2003 08:33 PM |
| gauges | Saltmaker | Windsor Power | 0 | 11-26-2001 10:08 AM |
| Aftermarket gauges in 85 dash, wire breakdown inside | RUSTANG | Windsor Power | 2 | 02-12-2001 11:06 AM |