Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-06-2002, 04:52 PM
|
#6 |
|
Registered Member
Join Date: Jan 2001
Location: Moline Il
Posts: 901
|
Is your bellhousing still bolted to the trans? I think it would be tough to install this way. Getting the input shaft to line up and engage in the clutch disc is going to be difficult. The easiest way for me is to drop the trans, then put it back in after the engine is in. But then again, I dont mind spending a little more time doing something, so as long as I'm not fighting it.
good luck! andy
__________________
88 coupe 91 LX NMRA Pure Street 5120 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Putting dual Flows | caliplaya650 | Classic Mustangs | 1 | 07-06-2001 01:45 AM |
| putting 94-95 ball joints on to 89 a-arms | John Cummins | Windsor Power | 0 | 06-18-2001 07:28 PM |
| Any inputs on putting a 32v in 87-93 stang | n20neenee | Modular Madness | 5 | 01-29-2001 09:44 PM |
| Any ideas for putting 32v into a fox body | n20neenee | Windsor Power | 6 | 01-26-2001 08:49 PM |
| putting a 2.3 svo turbo on an 88 efi? | Malachi2k | Small Ponies | 3 | 08-07-2000 08:21 AM |