Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-11-2001, 01:20 PM
|
#2 |
|
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
My Canton 7qt doesn't have the provision for the oil level sensor either. I didn't modify my pan to accept it, I pulled the bulb in the dash and clipped off the wires since I never planned on running it again, all my stock one did was leak and make a mess even after replacing the seal.
------------------ My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aftermarket oil pans? | blue00gt | Modular Madness | 2 | 07-19-2001 10:59 AM |
| 67 Convertible Floor Pans | Gichigumi | Classic Mustangs | 0 | 06-14-2001 04:12 PM |
| 351 oil pans! | bigredstang | Windsor Power | 4 | 05-28-2001 10:20 PM |
| 79-82 Oil pans | zodszoo | Windsor Power | 5 | 05-02-2001 06:29 PM |
| Floor pans? | 86GT | Windsor Power | 1 | 04-18-2001 09:24 PM |