Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-24-2002, 12:22 PM
|
#9 |
|
Registered Member
Join Date: Mar 2001
Location: Gainsville,Fl
Posts: 229
|
HYD
Well, I was running a Lunati 51018 cam and Crane lifters( supposedly high rev ) and we had some valve float, started at 6300-6500 rpm, also tried the lifters matched with the cam, basically all parts were matched and still, dyno showed HP drop offs. The work was being done by people who know their stuff also,( Lugos Racing ) 97 or 98, forgot which, NMRA champ.
Basically we went with a comp cams 31-762-9 and matched lifters(solid rollers)and valve components |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| building a stroker need advice on solid roller or hydrallic roller cam ?? | Mustangboy89 | Windsor Power | 4 | 06-06-2003 02:10 PM |
| What is a lifter? | SoulKeeper | Modular Madness | 7 | 05-09-2003 10:49 AM |
| Solid Roller ? | STROKER BILLY | Windsor Power | 5 | 11-19-2002 12:04 AM |
| Roller Lifter "oil hole" Q | drudis | Windsor Power | 11 | 03-05-2002 11:02 PM |
| Non roller to roller 351 block ????? | 88workcar | Windsor Power | 2 | 03-04-2001 12:45 PM |