Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-12-2001, 08:41 PM
|
#3 |
|
Registered Member
Join Date: Aug 1999
Location: Mtop,PA,USA
Posts: 46
|
I have called Vortech with the very same question. They stated the oil orfice is very small (a few thousands or something) and just sprays a fine mist of oil on the gears. The benifit of placing an oil cooler inline is very small due to the small amount of oil flow used to due to the small orfice. A engine based oil cooler would be beneficial though (and on my "to do" list too).
------------------ Tom Bukowski 92 GT A-Trim |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Oil cooler | GTSteed89 | Windsor Power | 1 | 05-30-2003 01:58 PM |
| What trany and Oil cooler to use? | Mustvid | Windsor Power | 0 | 05-27-2002 12:41 PM |
| Harder starts after head installation | SlowStang2 | Windsor Power | 5 | 08-10-2001 01:13 AM |
| Walbro inline fuel pump installation | Petey89 | Windsor Power | 1 | 06-22-2001 06:31 PM |
| Tranny cooler line blues | blue00gt | Windsor Power | 0 | 03-02-2001 06:03 PM |