Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-07-2002, 11:57 AM
|
#3 |
|
Registered Member
Join Date: Jun 2000
Location: Deer Park (Houston), Texas
Posts: 39
|
Clearance
DR, you can check you own clearance and make your decision where to drill. Use play dough in a baggie lay it on the valve train and smash your valve cover on top of it. This will make a perfect imprint a give you dimensions of clearances. I've got sheet metal valve covers and I need to do the same to weld bungs in them for vents. Hope this was helpful. The Force
__________________
 86 Capri "Don't Laugh It's Turbocharged!!!"
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Victor Jr. manifold is in - have questions about breather cap on valve covers | Stang_ROTY | Windsor Power | 2 | 08-19-2004 09:39 PM |
| Need tall valve covers + breather tube | Hozer 88GTConv | Windsor Power | 0 | 01-31-2004 10:58 AM |
| Is a valve cover breather bad for the 4.6???? | 96_4.6 | Modular Madness | 6 | 08-21-2003 06:38 PM |
| smoke out the breather valve!! | 82 GT | Windsor Power | 3 | 09-21-2002 02:01 PM |
| Why do I see some high performance engines w/ breather caps on the oil spout?????? | Stang_ROTY | Windsor Power | 24 | 08-18-2001 12:28 AM |