Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-25-2002, 05:01 PM
|
#10 |
|
Registered Member
Join Date: Mar 2002
Location: northeast Miss. (Stang Country)
Posts: 11
|
Any ideas on how to properly set the rocker arms? Right now they're just snugged tight. I turned the motor til each lifter sat completely down and snugged the rocker bolt tight (maybe 25 lb/ft).
Chevyguy: This 3.8 warped the heads and blew both gaskets! It looked like the gaskes died of old age or something!! Thanks graham
__________________
'97 Black Z28 6-speed. best 1/8th=8.53 
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine Block Casting #s | CHRIS75 | Windsor Power | 24 | 05-31-2004 04:03 PM |
| casting numbers | Sheldon | Built Ford Tough | 5 | 08-21-2002 05:58 PM |
| where is casting numbers? | srv1 | Windsor Power | 4 | 04-26-2002 02:51 AM |
| casting number | riceboyskiller | Windsor Power | 2 | 02-18-2002 07:43 PM |
| What do these casting numbers mean? | tra9379 | Windsor Power | 4 | 04-08-2001 02:42 PM |