Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-25-2002, 10:19 PM
|
#11 |
|
Registered Member
Join Date: Mar 2002
Location: Rockingham,N.C.
Posts: 80
|
You probally could have saved time and the hassle of the head gasket job ,ford has a recall on those engines and they do the job so you don't have to worry about it.Ihave seen some engines that got so hot it melted the oil cap slap off.As for the valve settings its just like a 302 ,turn the engine over until the lifter is on the back side of the cam lobe and tighten her up.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine Block Casting #s | CHRIS75 | Windsor Power | 24 | 05-31-2004 04:03 PM |
| casting numbers | Sheldon | Built Ford Tough | 5 | 08-21-2002 05:58 PM |
| where is casting numbers? | srv1 | Windsor Power | 4 | 04-26-2002 02:51 AM |
| casting number | riceboyskiller | Windsor Power | 2 | 02-18-2002 07:43 PM |
| What do these casting numbers mean? | tra9379 | Windsor Power | 4 | 04-08-2001 02:42 PM |