Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-15-2002, 02:07 PM
|
#1 |
|
Mustang Enthusiast
Join Date: Mar 2002
Posts: 528
|
calibration code?
I was hoping you would respond PKRWUD, thanks. Ok, I hope nobody rips me a new one, but what are calibration codes? I have both a Chilton's and a Haynes manual, but neither tell me where the vaccumn lines attach to the engine. I don't know what the calibration codes are, but if you tell me what they are, I could look them up in one of my manuals. Also, if I take a picture of what the engine looks like while it's in the car, will that help? Thanks in advance for the help!! -Keith
BTW: I went to Ford to see if they can tell me where the vaccumn lines attach, and they couldn't tell me. I looked through their Helm manual, and couldn't find any vaccumn line diagrams. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vacumn lines?... | Kamaro Killer | Windsor Power | 1 | 05-07-2002 11:25 PM |
| Broke two lines...Do I need new ones? | Stang_Crazy | Windsor Power | 4 | 01-11-2002 04:36 PM |
| Disk Brake Coversion - bending brake lines | glxstang | Windsor Power | 1 | 11-03-2001 11:23 PM |
| AOD HELP! Tranny lines leaking! | 88COBRA | Windsor Power | 1 | 09-06-2001 05:32 PM |
| EFI fuel lines and spark plugs | vangogh | Windsor Power | 0 | 02-20-2001 02:40 PM |