Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
06-06-2002, 05:50 PM
|
#1 |
|
Registered Member
Join Date: Oct 2001
Location: Joosey Shore
Posts: 358
|
Mother's sells a "cleaning polish" for detailing.
Go get some of that crap. Buy some high (I mean HIGH) count metal finishing sandpaper (like 300ct or more.... 440 is optimal) Very lighty and smoothly use the polish and sandpaper in a circular motion. That should work perfectly. However, if you use like wood sandpaper (100 grit) you'll need new lights cause they will be totally useless and destroyed.
__________________
1988 5.0 notch: Previously never modified!!  SN95 block front and rear seats, Mac catback, BBK off-road H-pipe, Steeda castor camber plates, Steeda lowering springs, Tokico shocks/struts, Alpine/MBQuart/PPI audio mods... |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Export tail lights? | Moxie | Appearance & Detailing | 2 | 03-02-2004 08:51 AM |
| Clear tail marker lights | 5P0INT0 | Windsor Power | 7 | 09-10-2003 06:53 PM |
| Need '83-'86 Tail Lights...Again | RMARIANI | Windsor Power | 1 | 04-13-2002 09:41 PM |
| Tail lights working on and off... | Badboy2777 | Small Ponies | 1 | 04-11-2002 12:08 AM |
| What wire gauge is used for tail lights? | Nitrous Al | Windsor Power | 4 | 11-15-2001 08:49 PM |