Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-08-2001, 02:37 PM
|
#5 |
|
Registered Member
Join Date: Mar 2001
Location: college station, tx
Posts: 143
|
I'm sure the stock one would work, but why skimp? It's probably not much less than the double roller.
------------------ Clint L. White 95 Cobra #3637 58cc GT40X heads with mild porting, Crane 2031 cam, FRPP 65 TB, 1.7s, Cobra intake, homeade cold air, 155lph, pullies, Tokico Illuminas, C springs, GW lower control arms, Steeda CC plates, aluminum driveshaft, Steeda quadrant, MSD6A, Mac shorties, off road hpipe, 2 1/2 ultra flows w/ dumps, R hood, Euro clear corners, stock 3.08s 13.61 @ 104.7 w/ 2.22 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| timing gears or chain? | 66StangGuy | Classic Mustangs | 8 | 11-09-2002 03:47 PM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| Ford Racing Timing Chain QUESTION. PLease HELP | 89FHPLX | Windsor Power | 3 | 06-27-2002 12:28 AM |
| Mech. fuel pump cam doesn't fit new timing chain? | 7000rpmisheaven | Windsor Power | 7 | 03-12-2002 08:55 AM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |