Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-12-2001, 01:56 AM
|
#15 |
|
Guest
Posts: n/a
|
My cam only came with one pin. Measure the approximate length and I will measure the length of the pin in my E cam fresh in the box in my room. It might depend on how deep the recess on the cam is, and how thick the timing chain is (dual roller vs. single). I am not for sure though. Maybe someone else can chime in and let us know for sure.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| timing gears or chain? | 66StangGuy | Classic Mustangs | 8 | 11-09-2002 03:47 PM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| Ford Racing Timing Chain QUESTION. PLease HELP | 89FHPLX | Windsor Power | 3 | 06-27-2002 12:28 AM |
| Mech. fuel pump cam doesn't fit new timing chain? | 7000rpmisheaven | Windsor Power | 7 | 03-12-2002 08:55 AM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |