Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-10-2001, 08:58 PM
|
#11 |
|
Registered Member
Join Date: Jul 1999
Location: INDIANAPOLIS
Posts: 404
|
I like my plain old common edelbrok 6032's. (ex. ported)and I have the small valves too. Velicity builds torque. Don't go too big with a street car. I think I might try the victor jr's next. You cann't go wrong with Edelbrok on it. Best time 10.13@135 mph
------------------ 302,vortech s trim @18-20lbs showing,edelbrock performer heads-o ringed,gt 40 upper&lower, mac 1 5/8"long tubes, sub frame connectors,50/50 rear, 70/30 front, manual rack,3:55 gears, c4 , best time 10.13@135mph |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rocker adjustment | zach0 | Classic Mustangs | 3 | 04-24-2004 12:28 PM |
| Pulling cylinder head tips | Hozer 88GTConv | Windsor Power | 2 | 03-04-2004 03:05 PM |
| After all normal bolt-ons... cylinder head questions | RED92LX50 | Windsor Power | 9 | 06-14-2003 08:43 AM |
| 289 cylinder head on 5.0L???? | FiveORacer | Windsor Power | 2 | 05-16-2001 04:02 PM |
| Cylinder Head Swap | Fostang | Windsor Power | 0 | 05-05-2001 09:51 PM |