
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
#3 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
The clutch that you installed is approximately twice as stiff as the stocker. You can get a "stock feel clutch"
That couldn't be a more wrong statement. The king cobra clutch kit has 140% the holding power that the stock clutch does. However, because of increased designed the pedal feel of the king cobra is 10% less than stock. I just installed a king cobra clutch and the pedal feel almost none existant compared to the old clutch. I know with the tremec that almost none of the stock drivetrain works. You need a different clutch, input shaft(i believe), and bell housing. Your new king cobra should not feel anywhere near harder than stock.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| clutch problem | Torinalth | Modular Madness | 3 | 03-24-2003 12:19 AM |
| Tranny won't shift! (long) | byrnech | Windsor Power | 4 | 08-26-2002 10:50 AM |
| '65 Mustang - Pull Away Problems | geordie | Classic Mustangs | 6 | 05-11-2002 04:46 PM |
| 4cyl clutch pedal vs 5.0 pedal? | WADS56 | Windsor Power | 5 | 02-05-2002 02:27 AM |
| Clutch Quadrant?? PLEASE help! | Chris_H | Windsor Power | 8 | 03-05-2001 11:00 PM |
