Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-14-2002, 10:11 AM
|
#2 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
I had a difficult time with mine. You have to remove the drivers seat and work upsidedown and jam your hands up into the quadrant area. it is very easy to cut your hands on the stamped steel pedal suport and the studs for the seats can be painful is you accidentaly roll on them. Depending on what the shop charges, I would let them do the work.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone got a diagram or picture of clutch quadrant installation? | 5pointohboy! | Windsor Power | 1 | 10-03-2004 08:45 PM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| clutch quadrant - easy? | blk88lx | Windsor Power | 4 | 04-02-2002 02:12 PM |
| shift kits...easy to install? | 82 GT | Windsor Power | 1 | 02-07-2002 10:46 AM |
| easy subframe install on a '91 convertible? | stanger8172 | Windsor Power | 5 | 07-03-2001 08:10 AM |