Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-04-2001, 11:44 PM
|
#3 |
|
Registered Member
Join Date: Apr 1999
Location: Hayes, Va, USA
Posts: 798
|
I was always under the impression that with a new set of heads (especially aluminum), you ran then engine up to operating temperature then let it cool down and retorque the cylinder heads? this allows the engine to completely cycle thermally.
My advice go to http://www.n2performance.com/index.html and ask the Jim McFarland, he's the former engineering guru at edelbrock so if anybody would have a no BS answer he would |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Do I need new head bolts? | skiwesser | Windsor Power | 15 | 12-06-2002 10:31 PM |
| Lower head bolt's ????? | vande97 | Windsor Power | 2 | 03-27-2002 08:12 AM |
| Outer head bolts go thru water jackets?? | gp001 | Windsor Power | 11 | 09-01-2001 02:05 AM |
| head bolts | matt cook | Windsor Power | 8 | 03-16-2001 05:00 PM |
| Head bolts | stanger8172 | Small Ponies | 1 | 11-27-2000 01:41 AM |