Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-23-2002, 11:03 PM
|
#7 |
|
Registered Member
Join Date: Jan 2002
Location: Mt. Prospect,IL
Posts: 474
|
well i didnt buy the install kit i bought the stuff sepratly i just got to get the timing straightend out then break the motor in and tell u what i run
__________________
87-ford-mustang-SOLD! mods: 3:73's, off road h-pipe, b303 cam in gt- 40 motor w/ Power Plus intake, edelbrock 70mm tb & egr spacer, 72mm C&L, bbk long tubes, tremec tranny, centerforce dual friction clutch, upr and lwr CA's 255lph FP and soon more to come.... when i have money again SOME ADVICE Don't do burn outs in reverse it is very expensive New times with dead hook on dr's 13.27@103 with 2.0 60 foots w/100lb system Fastest time to date: 12.8@113 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Z28 vs. "GT" | Smokedawg | Stang Stories | 30 | 05-13-2005 02:12 AM |
| Is it possible to pass a 96-98 4.6 gt engine off as a cobra somehow?read! | 96_4.6 | Modular Madness | 20 | 11-24-2002 10:20 PM |
| GT40 crate engine into a 94-95 gt | dlb1982 | Windsor Power | 1 | 09-22-2002 06:32 PM |
| 83 mustang 5.0 with a 340 hp ford crate motor should I go carb or efi??? | fantozi | Windsor Power | 9 | 08-07-2001 05:10 PM |
| GT-40p headed motor | 89 Cobra LX | Windsor Power | 5 | 06-15-2001 06:46 PM |