Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
09-24-2002, 03:24 PM
|
#1 |
|
Moderator
Join Date: Mar 2001
Location: Myrtle Beach SC
Posts: 1,643
|
I installed a set of Poly bushing in all my rear control arms last night. I had the rear end completely outta my car building it up for drag action so I had the arms off the car anyway. I used a torch to get the old ones out. just burnt them out. They could be pressed out with a vise or press but I like fire......
 I used a HEFTY amount a grease to install the new ones, I put grease on the arms and on the bushing when I pushed them in. Had to use a hammer a little to get them in but they really wernt that hard to do.Bradley
__________________
1990 GT, 347, TFS TW Heads, TFS Cam, TFS Track heat, Twin turbos, FMIC, T5. Built Ford Tough Moderator |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Polyurethane Bushings | TMASTER | Windsor Power | 4 | 11-06-2002 11:52 PM |
| Front control arm bushings..."Not Serviceable"??? | flyin 5.8 | Windsor Power | 4 | 05-16-2002 03:55 PM |
| Poly UCA bushings (axle-side)? | blueneonman1 | Windsor Power | 0 | 11-20-2001 10:12 PM |
| best set of suspension bushings? | stng87 | Stang Stories | 2 | 04-15-2001 09:01 PM |
| sway bar bushings... | Red96GT | Corner Carvers Delight | 3 | 12-13-1999 04:31 PM |