Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-03-2002, 04:44 PM
|
#7 |
|
Registered Member
Join Date: Sep 2001
Location: ORANGE PARK FL. USA
Posts: 208
|
I had a vibratioon at about 6K rpms in 4th gear with the stock drive shaft. After I put in the aluminum shaft in the vibration was gone. Also I did notice a differance in highway driving vibrations. Not much, but there was a differance. My stock drive shaft did have 180K miles on it though.
__________________
91 LX COUPE, 3.73 gears, 2 1/2 inch H-Pipe, 1 5/8 MAC long tube headers, 73 MM C&L MAF, 70 MM MAC TB, LUNATI cam,1.7 TFS Rockers, TFS Track Heat heads, TFS Track Heat intake, T5 with PRO 5.0 shifter, Griffin aluminum radiator, Fluid Damper, SSM traction bars, 190 GPH in tank fuel pump. And more to come. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tremec 3550, aluminum fly & clutch INSTALLED! | 302 LX Eric | Windsor Power | 3 | 10-01-2001 04:05 PM |
| got my FMS aluminum driveshaft | todd95GT | Windsor Power | 9 | 09-06-2001 09:27 PM |
| 95 GT - How bad is my computer hurting my performance? | K.C. 5.0 | Windsor Power | 4 | 07-28-2001 08:36 PM |
| Aluminum Driveshaft...Balance? | chris91LX | Windsor Power | 4 | 02-10-2001 12:43 PM |
| WARNING ABOUT PERFORMANCE AUTOMATIC | 84GT+NOS | Modular Madness | 1 | 09-15-2000 09:04 AM |