
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
|
|
#1 |
|
Registered Member
Join Date: Oct 2002
Location: tampa, fla
Posts: 6
|
1st off; no splines on pressure plate only on clutch disk.maybe you're talking about pressure plate fingers where the throw-out bearing rides on? spec probably good deal. but would not use better value for sales pitch, cheaper doesn't mean same as value. you get what you pay for. think about tremec 3550. $1250 or t-5 $1150 which is better deal?. not tryin/ to be smart *****.tryin to see why you think it's better deal, is it money or preference? if t-5 was better deal/value no one would buy tremec 3550. do you get what I mean? all mater of opinion. ![]() |
|
|
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| Clutch Problems | blue302 | Windsor Power | 3 | 09-10-2001 01:37 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |
