Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
10-12-2002, 02:07 AM
|
#1 |
|
Registered Member
Join Date: May 1999
Location: Indiana
Posts: 512
|
A friend gave me one off of his 93 Cobra and was saying that the Cobra's were underdriven from the factory, but I discovered that it is EXCATLY the same size as what came on my car... They both measure out to just about 6 3/16 OD. I am getting belt slippage and want to try a slightly bigger pulley.
__________________
92GT Lowered with Ebiach's and Koni's, Kenny Brown subframe connectors, lower G-brace and jacking rails. BBK upper and lower control arms, polyurethane bushings all around and Ken Bell blower, ram-air, 80mm mass air, SMC Alky Injection kit, J&S Knock Gaurd, TwEECer RT and a bunch of other stuff! |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| QUICK: What belt size for 7in crank pulley with a 3.33in charger pulley? Vortech... | JaxMustang50 | Power Adders | 0 | 05-01-2003 06:44 PM |
| ? about a crank pulley!!!! | 90LXhatchback | Windsor Power | 3 | 02-21-2003 04:36 AM |
| alternator pulley to crank pully ratio | redrider | Windsor Power | 0 | 12-18-2002 11:43 AM |
| ASP crank pulley help | terrible0ne | Windsor Power | 3 | 03-28-2001 02:28 PM |
| Piggyback pulley problems! (long) | Mustang92 | Modular Madness | 3 | 01-16-2001 10:24 PM |