Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-19-2002, 08:31 PM
|
#2 |
|
Registered Member
Join Date: Jun 2002
Location: Southern California
Posts: 109
|
Now for the intake stuff:
------------------------------------------- "Edelbrock Performer Intake Manifold" EDL-2750 http://store.summitracing.com/partdetail.asp?part=13584 ------------------------------------------- Heres the intake manifold bolt kits from edelbrock, but theyre also listed for 351M and 400M motors... will they work for the Cleveland intake also???? ------------------------------------------- "Edelbrock Intake Manifold Bolt Kit" EDL-8574 http://store.summitracing.com/partdetail.asp?part=14904 ------------------------------------------- Heres the Summit carb studs: ------------------------------------------- "Summit Carb Stud Kit" SUM-G1423 http://store.summitracing.com/partdetail.asp?part=10594 ------------------------------------------- So far so good.... I HOPE......... Now for the gaskets: ------------------------------------------- "Fel-Pro's quality high-performance gaskets" FPP-1240 http://store.summitracing.com/partdetail.asp?part=5771 ------------------------------------------- Did i forget anything? Thanks for all your help!!! i really dont wanna screw anything up....... Thanks alot!
__________________
 1973 Mustang Coupe 351 cleveland 2v heads Edelbrock Performer Intake, Holley 600cfm carb Hooker Headers, 2.5 inch pipes, Magnaflow X-pipe, Flowmaster 2 chamber mufflers with turndowns. Stock Fmx tranny and 2.75 rear end My website:http://www.geocities.com/spddemontc User Rides Index: http://www.mustangworks.com/cgi-bin/...splay.cgi?2541 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|