Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-20-2002, 01:08 PM
|
#17 |
|
Registered Member
Join Date: Feb 1999
Location: Houston,TX
Posts: 466
|
It wouldn't hurt but I don't think it would be worth the investment. If you are really looking to get more cam i would recomend either a custom mega $$$'s or a melling 24211 it is a REAL stout on the edge of steetable cam but then your intake will be lagging an open spacer would help some.
My suggestion would to be get the gears and an open carb spacer first and go from there.
__________________
A good plan, violently executed now, is better than a perfect plan next week. George S. Patton, General (1885-1945) |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems with RPM's | cgg074 | Modular Madness | 2 | 09-29-2003 10:12 PM |
| Motor breaking up past 3000 rpms. Gurus I need your help!!! | Miguel | Windsor Power | 0 | 08-13-2002 08:08 AM |
| pushrod vs. O/H cammer RPM ranges | Mach 1 | Windsor Power | 2 | 07-27-2002 01:46 PM |
| where are the 30 buck intake spacer ? | southernstang97 | Modular Madness | 10 | 07-19-2002 02:22 PM |
| Help!!1Nasty Driveline vibrations above 2800 rpms | goduke | Windsor Power | 2 | 01-29-2001 12:54 AM |