Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-28-2001, 12:23 PM
|
#4 |
|
Don Corlione
Join Date: Jun 2001
Location: Omaha NE USA
Posts: 491
|
This is very odd. Does the car run like complete sh!t? I'm pretty sure the speed density computers were designed to run specifically on the stock cam specs. You don't see a mass-air sensor anywhere along the intake tract?
------------------ Eric - 89 Mustang LX coupe 302 - Cobra Intake - GT40p heads - TFS stage 1 cam - FRPP 1.6 roller rockers - Naturally Aspirated 3.73 gears - KYB shocks and struts - Eibach springs - HPM Mega-bite Jr lower control arms - HPM upper control arms |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tuning a speed density system with mods | Fostang | Windsor Power | 6 | 07-10-2002 11:32 PM |
| First ticket. Sucks, sucks bad. | zepherman | Blue Oval Lounge | 46 | 12-16-2001 07:24 PM |
| EFI conversion with Speed Density and a 351w? | PSI GUY | Windsor Power | 2 | 12-02-2001 11:13 PM |
| speed density question.. | bobtodd | Blue Oval Lounge | 2 | 04-15-2001 02:03 AM |
| Speed Density question (92 F150 5.0 E4OD) | 98GT4me | Small Ponies | 1 | 03-29-1999 08:07 AM |