Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-23-2003, 09:10 PM
|
#9 |
|
Registered Member
Join Date: Aug 2002
Location: Jacksonville,Fla.
Posts: 134
|
I use ARP studs in my setup also,no problems at all removing the heads and you can torque them down a bit tighter,the studs are basically used in racing applications as not to wear the block threads out due to frequent removal,and as Chris stated they are stronger and give more accurate torque readings,I recommend them highly.
__________________
Jack 1989 Mustang LX: Converted to Carb.650 AED Holley DP,Weiand Stealth Intake,Edelbrock Performer RPM Aluminum Heads,Hooker Super Comps, Ground Pounder Uppers and Lowers,Moroso Drag Springs,NEW COMP Xtreme Energy Cam and 1.6 RR. ,a few other goodies.*** New 1/4 times-12.50 1987 SC GT ( fast as hell) 2001 Powerstroke Tow Vehicle 1989 Coupe.  Sometimes when you cry,no one sees your tears.......... Sometimes when you are happy,no one sees your smile......... But,FART just ONE time.......... |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best way to remove head studs? | Hozer 88GTConv | Windsor Power | 3 | 03-12-2004 07:59 PM |
| Head Studs | speedytang | Windsor Power | 3 | 09-17-2002 11:30 AM |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| ARP Head Stud install | Prochrgd1 | Windsor Power | 7 | 03-27-2002 01:31 AM |