Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-26-2002, 02:07 PM
|
#1 |
|
Registered Member
Join Date: Mar 2002
Location: Lansing
Posts: 2
|
ARP Head Stud install
I'm starting my first engine buildup this weekend & have a few question's about these ARP Head Studs I bought. First off, ARP recommends only hand tightening the studs into the block. Do I oil the threads that are going into the block? If so, what about the studs that are going into the water passages? Will the thread sealant "set-up" if I thread oiled studs through the sealant? The last thing I want to do is tear back into the engine to replace head gaskets after all the time & money I've put into this so far. Many thanks to those who reply.
Jake All forged & Procharged 94 Cobra |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Broken head stud, hmmm. | Hozer 88GTConv | Windsor Power | 4 | 03-12-2004 08:03 PM |
| Head Install | BlueMust5089 | Windsor Power | 12 | 05-15-2003 03:50 PM |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| stud mount rocker install | Blown 306 | Windsor Power | 2 | 05-13-2001 10:25 AM |
| Edelbrock Head Install Questions | Blaster | Windsor Power | 5 | 05-10-2001 12:22 PM |